| Article Index |
|---|
| Danger Den Maze 4-1 GPU Guide |
| Page # |
| Page # |
| Page # |
| Page # |
| Page # |
| All Pages |
Page 5 of 6
Danger Den Maze 4-1 GPU Guide
Once
your happy with the trimming and fit, you can peel off the protective
backing paper and stick it on top of the thinner gasket.
Again make sure to press down firmly getting rid off all air
pockets.
When your satisfied the thicker layer is stuck firmly on top of the thinner layer, you can smear a liberal amount of Dielectric Grease to the inner edge of the pre-cut hole and offer up the GPU Block so that it is sitting on top of the GPU core correctly. Pack up any gaps between the gasket and the cold plate with liberal amounts of grease so no air is able to come into contact with the copper cold plate or peltier.
When your satisfied the thicker layer is stuck firmly on top of the thinner layer, you can smear a liberal amount of Dielectric Grease to the inner edge of the pre-cut hole and offer up the GPU Block so that it is sitting on top of the GPU core correctly. Pack up any gaps between the gasket and the cold plate with liberal amounts of grease so no air is able to come into contact with the copper cold plate or peltier.
At
this point your installation may now differ from the card I have
here. If you donÙt plan on using any heat sink on the reverse of
the card, you can flip the card over and stick the last piece of 3/8”
pre-cut Neoprene onto the back of the GPU core. Basically this means
both sides of the card are completely covered, sealed and almost ready
for action.
A
good safety tip is to run a bead of Dielectric Grease around the
entire outer edge of the Neoprene Gasket with your finger where it
meets up with the PCB board on both front and back sides of the card.
Your now ready to start adding the rest of the mounting hardware and hold down device to the 2 threaded posts sticking through the card from the GPU block . First slide on 1 of the T shaped nylon washers followed by a spring followed by another T washer and repeat on the other threaded post.
Your now ready to start adding the rest of the mounting hardware and hold down device to the 2 threaded posts sticking through the card from the GPU block . First slide on 1 of the T shaped nylon washers followed by a spring followed by another T washer and repeat on the other threaded post.
Now
you can slide on the Lucite brace followed by a normal nylon washer on
each post and finally the brass thumb screws. Tighten down equally so
that the block is firmly secured - finger tight is fine.
Advertise here - fantastic rates starting from £50
Celebrity Gossip
Advertise here - fantastic rates starting from £50
